PDA

View Full Version : AWD motor set-up


lfisminiz
2007.07.08, 06:42 PM
I remember seeing it, but cant find it. With a non awd motor. Whats the right way to wire it, capaciters etc...to make it work with the awd chassis. Im thinking something is different from an 02 chassis motor vs. an awd chassis motor? Thanks.

Aurora
2007.08.01, 02:48 AM
lfisminiz,

Just for the info (and you probably might have known this), I usually wire the motor in the following manner (with an AD band board):

1) unsolder the original wires and caps
2) orient the motor with the wire connecting side facing upwards, the arm to the left
3) file the side of the case for soldering the cap
4) solder the cap such way that they are either tug in at the end ball or planted flat to the case, at two sides of the case closer to the top
5) solder the positive wires on the far side of the connection pad, and let the motor connecting side lead forward to the arm side.
6) Solder negative wire closer to you on the connection pad, and let the motor connecting side lead forward to the arm side.
7) connect everything without the batteries


Hope this helps. :)