View Full Version : HELP...Full throttle problems
fpipo
2008.03.25, 09:13 PM
I receive my new car and I setup the control With the manual but If I pull to full throttle the motor Stop.
I do not know what I need to move to correct this, any Help?.
Regards
herman
2008.03.25, 10:44 PM
greetings and welcome to the forums...
try adjusting throttle trim push it up till car's wheels move forward...
here's something i posted regarding reverse, but you can use it to initially adjust / set your throttle... http://mini-zracer.com/forums/showthread.php?t=27704
1. basically raise your car off the ground (so it doesn't run off unsuspectedly) fiddle around with the throttle trim (press A/up) till the wheels start moving forward
2. then adjust throttle trim (press B/down) till the wheels stop, then press B a few more times until beeping sound from the chassis stops
3. finally press B 8 more times (might be 7,8,9 or more - i guess 8 is more or less the benchmark)
reverse should work a lot better now. almost like the am mr02 chassis...
you can use this method if your car is initially going in reverse - just press A till it goes forward. then go through the whole process again...
if it still doesn't work, try to reset the transmitter.
hope this helps...
If the motor stops when going full throttle forwards, try changing the batteries in the radio. This could help.
Racer-HH
2008.03.28, 05:09 PM
Try resetting the radio. This solved this problem for me.
Racer
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.