PDA

View Full Version : now what


yamar6
2008.04.03, 08:40 PM
i buy a new motor new batteries and ball diff.put everything on and it just spin in a circle.stearing works and sometimes the car don't move.i have to wait a couple of secounds and then it goes batteries are in tight.now my radio sometimes freezes the buttons work then they don't.:mad:

yamar6
2008.04.03, 08:55 PM
ok i changed the back tires to stock.i had GPM ones on it hooked nice then started spinning.i just think it is my floor.but sometimes it don't want to go.i'll put it in reverse then it goes if i brake i have to put it in reverse then go foward.

EMU
2008.04.04, 01:00 AM
Have you adjusted the ball diff? You cant just install it and expect it to work, it needs to be adjusted to differentiate properly.

Loosen it a little, to the point that you can move the spur with your finger while holding the rear wheels. You dont want to be able to move it easily, but you dont want it too tight.

fangel
2008.04.06, 10:01 PM
There might be a few reasons why this has happen.
It might be because of the Tire and floor matching, or it might be the differential setup.
Also the problem with the reverse and forward problem might be about the ABS throttle.
Try turning it off and see if it helps the situation.

yamar6
2008.04.06, 10:57 PM
ok thanks.There might be a few reasons why this has happen.
It might be because of the Tire and floor matching, or it might be the differential setup.
Also the problem with the reverse and forward problem might be about the ABS throttle.
Try turning it off and see if it helps the situation.