PDA

View Full Version : AWD 2.4ghz board in an F1


lightwes
2008.07.19, 08:17 PM
Has anyone tried using the AWD drive 2.4 ghz board in a F1? I noticed the wires are longer so you may not have to extend them, is this the case? I am just not thrilled about buying a new 2.4 ghz board and modifying it to fit in the F1.
Thanks

cowboysir
2008.07.19, 08:31 PM
ruf and cristian have done the hard part...look down about 6 or so threads for the tut.;)

lightwes
2008.07.19, 08:36 PM
I saw the tutorial but noone really states wether the AWD or MR-02 was better from what I saw.
Thanks

cowboysir
2008.07.19, 08:46 PM
my guess is that it's the same board but the mr02 version would be slightly better for wiring. Without reviewing the thread again I would think the only real challenge would be the on/off switch length.

If I recall, people were having to shorten the mr02 wires to fit it into an AWD before they came out with specific length kits to switch out boards.

lightwes
2008.07.19, 09:21 PM
Ok Great
Thanks

ruf
2008.07.20, 06:35 PM
I saw the tutorial but noone really states wether the AWD or MR-02 was better from what I saw.
ThanksYou sure you're looking at the right tutorial?

http://www.reflexracing.net/ASFF1_conversion.asp