PDA

View Full Version : 2.4ghz AWD board question.


wight
2008.07.31, 10:32 AM
Hi all.Just wondering why there is a specific awd board available?
I do not have an AWD chassis so do not know what would be different about this board and one that would fit in the 2wd chassis.
Being fairly new to the hobby and ignorant,I thought the pcb's where all interchangeable between chassis types?

hrdrvr
2008.07.31, 10:34 AM
The PCBs are all interchangable. The only differences are the wire lengths for the servo, POT, power leads, and the on/off switch.

EPM13
2008.09.22, 10:09 AM
Would anyone happen to know, are the wires longer on the AWD PCB or the 2WD PCB?

Thanks.

ChiefGreenLeaf
2008.09.28, 09:30 PM
Would anyone happen to know, are the wires longer on the AWD PCB or the 2WD PCB?

Thanks.

The Mr-015/02 are longer.

eztuner12
2008.09.30, 12:02 AM
Not very sure, but I think the servo motor polarity wires are soldered opposite between the MR-02 and the MA-010AWD, so the rotation of the servo motor are different. You should investigate more about this mater.
Cheers

Cherub1m
2008.09.30, 06:59 AM
Check this thread out(go down to 2nd page). Its a nice article written my ruf about the AWD conversion to ASF.

http://www.minizracer.com/forums/showthread.php?t=27735