PDA

View Full Version : Atomic Titanium Screw Set


addicted
2009.09.17, 06:00 AM
Hi,
I'm just setting up converting to the blue/grey SP chassis from the default AWD one, and also have the atomic titanium screw set (for the hex).

Now i've ran into a problem.

I've accounted for all the screws by just putting them in the parts that they will be needed in, but i am left with 0 for the front clip mount/ or the motor/board mount.
I've used the following:

The screws below are setup already, and are definately the right screws.
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/screws01.png

The screws below are potential screws, which all match what the old chassis was, and match the guide in the new chassis setup.
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/screws02.png

The screws below are the final screws which seem to be the correct ones, but then leaves me with no screws for the front clip.
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/screws03.png

Hopefully someone with some experience with these screws can guide me, as im well confused now, and i would have to buy another set of the screws just to get two for the front clip!
From what i can see, im assuming either try not to use some of the screws (eg rear plate changed with S.A.S would free up at least 4 screws), or perhaps the battery terminals with the original black screws, leaving the smaller ones for the front clip.

mk2kompressor
2009.09.17, 08:49 AM
the 2 smaller stock screws from the servo cover shown in the last pic to the left need to be re-used:)

addicted
2009.09.17, 08:52 AM
ahh right!
thanks dude!
don't suppose you'll be at the stafford race meeting by the way?
would be nice to race/meet you as you've helped me out alot!

addicted
2009.09.17, 11:13 AM
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/DSCF0947.jpg
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/DSCF0948.jpg
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/DSCF0949.jpg
http://i72.photobucket.com/albums/i167/Addicted_ja/Mini-Z/DSCF0950.jpg

all done! :)
ready for sunday, just gotta get some proper offset wheels for the evo 8 i got!

Programmers
2009.09.17, 11:19 AM
Beautiful! :D

mk2kompressor
2009.09.17, 01:44 PM
ahh right!
thanks dude!
don't suppose you'll be at the stafford race meeting by the way?
would be nice to race/meet you as you've helped me out alot!

anytime,thats what im here for;)
no time this weekend but i will be attending one hopefully soon:)

addicted
2009.09.17, 02:11 PM
ahh okies no probs!