PDA

View Full Version : mr03 94mm setup.


hpgod
2010.01.04, 05:55 AM
problem
pn 94/98 damper plates hit the ics/giro ports. I use the port for the lap counter to plug into.
3-racing same issue.

What is the prefered solution atomic 94mm plate only?
Raise the disc damper?

How have you all built the rear end of your 94mm/soon to be 96mm mr03s?

mk2kompressor
2010.01.04, 06:15 AM
pn dd with the front 2 tabs cut off for access to the plug.
you may still have to cut the atm one to fit too(the plastic bridge under the plate needs cutting)

mleemor60
2010.01.04, 07:53 AM
Kyosho part number MZW411. Start there.

JeremyC
2010.01.04, 09:08 AM
problem
pn 94/98 damper plates hit the ics/giro ports. I use the port for the lap counter to plug into.
3-racing same issue.

What is the prefered solution atomic 94mm plate only?
Raise the disc damper?

How have you all built the rear end of your 94mm/soon to be 96mm mr03s?

I use the PN carbon plate and had the same problem. A Dremel cutting wheel makes short work of the plate. I trimmed mine down to fit the plug.

blt456
2010.01.04, 11:49 AM
I never had mine hit the ports just sit over them. What I do is dremel out the little space that separates 949/98 on the plate and make the inside a rectangle. This allows me to adjust all wheelbases and when you plug in a gyro or transponder via ics, you can just slightly undo the 2 top screws like 1/2 a turn and slide the plate back.. very simple

JeremyC
2010.01.04, 12:12 PM
I never had mine hit the ports just sit over them. What I do is dremel out the little space that separates 949/98 on the plate and make the inside a rectangle. This allows me to adjust all wheelbases and when you plug in a gyro or transponder via ics, you can just slightly undo the 2 top screws like 1/2 a turn and slide the plate back.. very simple

This is probably the better way to do it. The way I did it my damper plate is now only usable for 94mm.

TeamEpsilon
2010.01.04, 06:38 PM
is that the kyosho t plate part number?

mleemor60
2010.01.04, 06:49 PM
If you are asking about MZW411 it is the Kyosho damper plate set for the 03