PDA

View Full Version : will a MR02/RM motor case fit 015


Mead
2010.07.15, 10:26 PM
I m thinking about getting this for my MR015, but will it fit? I know T-plate lenght is different but other than that will it work?

http://www.shopkyosho.com/products/productdetail/MOTOR+CASE+SET%28MR-02/RM+TYPE%29/part_number=MZ210/410.0.1.1.25387.25476.25396.0.0?

MZ210 MOTOR CASE SET(MR-02/RM TYPE)

Skv012a
2010.07.15, 10:42 PM
Plate lengths are only different for MM or RM motor pods. MR-xx cars' rear ends are all compatible with one another, only front end/chassis parts vary to a degree.

Mead
2010.07.15, 11:15 PM
Thanks for the reply.

One of the reasons Im needed a motor case set is the 'snap on' cover keeps breaking, ie the tabs keep fracturing, do you know anyone that makes an alloy version in HM / RM spec? (they are the same cover), I like to stick with Kyosho stock motors so I'm not looking into PN right now...

Eman
2010.07.16, 02:21 AM
I think 3Racing makes a RM mount that allows the use of the stock motor.

Mead
2010.07.16, 10:51 AM
Sweet, thanks.

Looking at the 3Racing part, does that heat sink cover work with Kyosho's plastic motor mount?

http://shop.tinyrc.com/t_images/3RA-RMII-003-a.jpg

Anyone know if it works?

Skv012a
2010.07.16, 12:33 PM
May or may not. I think Kyosho themselves make alloy mounts as well as Route246 that can work with a stock motor. Your other option is to get any aftermarket motor and a mount and save yourself some headache.

Mead
2010.07.16, 04:27 PM
cool, thanks, good advice.

just found out HM and RM do not share the same cover piece