PDA

View Full Version : Part Question


arch2b
2010.07.17, 11:49 PM
PN Racing Mini-Z MR03 Pro Front Lower Arm Set Wide
MR3052W

in putting this together, i managed to loose on of the c or e clips for the knuckle shaft. these are smaller than the typical clips. where can i purchase replacements?

http://www.rckenon.com/public_html/shop2/catalog/images/MR3052W.jpg

lfisminiz
2010.07.17, 11:56 PM
Raymond, not 100% sure but i think its the same ones as the A-arm.

arch2b
2010.07.17, 11:58 PM
are those sold separately? i don't have an a-arm anymore and not spending $80 to get some clips.

lfisminiz
2010.07.18, 12:02 AM
Check Kenon. I know they were sold.

lfisminiz
2010.07.18, 12:05 AM
Ray.... MR2503 PN Racing Mini-Z Double A-Arm King Pin E-Ring (10pcs) In Stock USD$2.38 :)

arch2b
2010.07.18, 12:07 AM
Larry, my hero :)

http://www.rckenon.com/public_html/shop2/catalog/images/MR2503.jpg

lfisminiz
2010.07.18, 12:09 AM
:):):):):)

byebye
2010.07.18, 07:36 AM
Just FYI-If you run the king pins upside down as prescribed by Pn you only need the two for the top.
EDIT: That's assuming if you use PN Upper Arm MR3033 MR3034 and MR3035
http://i55.photobucket.com/albums/g153/toffe777/DSCF0373.jpg
http://i55.photobucket.com/albums/g153/toffe777/DSCF0374.jpg
Kris