PDA

View Full Version : PN Racing Mini-Z MR03 Pro Front Lower Arm Set


dgomes
2010.08.22, 10:41 AM
Hello,

I recently purchased a MR3052WS Pro Front Lower Arm Set.

I was, however, already using a long king pin replacing the original ones and repositioning the springs.

However, the MR3052 has its own king pin system...

Does any one knows if there is a way to use the long king pin on the Pro Front Lower Arm Set?

Alternatively, is there a long king pin for the MR3052?

Best regards,
Daniel

color01
2010.08.22, 01:47 PM
There are no MR-03 kingpins other than the provided ones that will fit in the aluminum lower arm, as you must pivot the Delrin ball into the aluminum mount. So the Reflex kingpin will not work in this part. Although this is not supposed to be supported, you may have some luck fitting an MR-02 kingpin into the special Delrin ball you received in the package for the pro lower arm -- that will be long enough to use the coil-over spring configuration. Hope that helps.

chad508
2010.08.22, 02:02 PM
you can use an 02 king pin pushed into pn ball. this is what i do in the plastic arm as the rr king pins are just a little to long and the 02 pins work just fine.

dgomes
2010.08.22, 02:55 PM
Thank you guys!

I will definitely try that.

Best regards,
Daniel

GIHOSU
2010.12.16, 01:42 PM
Are there any plans to make a narrow version of this part?

I use the current version and I like the results.

moz
2011.01.09, 08:21 PM
Are there any plans to make a narrow version of this part?

I use the current version and I like the results.

I also want the narrow version :D...MR PN please help us