PDA

View Full Version : Futaba 2PL Question


KA2AEV
2010.09.14, 07:50 PM
Okay this is probably a dumb question that will take someone all of 5 seconds to answer but I cannot figure it out for myself

Anyway is there a way on the Futaba 2PL AM transmitter to back the
throttle setting down from 100 % when the trigger is fully depressed
to say 80% when the trigger is fully depressed

Any thoughts?
Mike

EMU
2010.09.14, 09:03 PM
Yes, its called the endpoint adjustment. 2PL has it. If I remember correctly, the AM Mini-Z uses about 70, any higher and its just going to give you less resolution and you will hit full throttle with less trigger pull. I dont remember the menu system, but there arent many functions, so just find EPA, and adjust channel 2.

KA2AEV
2010.09.15, 04:16 PM
Yes, its called the endpoint adjustment. 2PL has it. If I remember correctly, the AM Mini-Z uses about 70, any higher and its just going to give you less resolution and you will hit full throttle with less trigger pull. I dont remember the menu system, but there arent many functions, so just find EPA, and adjust channel 2.

Okay thanks Eugene
The manual for the 2PL is less than desirable
Really do think they could have done a way better job of explaining
the how to and meanings of alot of the settings on it
Seeya Friday

acerpower
2010.09.17, 03:07 PM
On channel 2 I have my forward set to %59 for my MR02.

I seldom use a manual for anything, especially if it was manufactured in another country. They usually miss allot in the translation.:confused: