View Full Version : MR-03 board Fet job (Stacked) photo request
SaiTam
2010.11.30, 10:37 AM
I did a 3 layer stack and only to find out later that it does not clear the chassis top cover left rear hole. How did you do yours? Thanks in advance.
http://i9.photobucket.com/albums/a65/dealerxing/Mini-z/IMG_0739.jpg
arch2b
2010.11.30, 12:39 PM
slanted stacks likely. i'm sure someone here has photos.
yasuji
2010.11.30, 12:48 PM
wow 3 on top.... how many on the bottom?:eek:
we do 2 on the bottom and 1 on the top!
SaiTam
2010.11.30, 03:39 PM
Bottom pads are destroyed. I will go with 2 layer or single. Thanks.
pinoyboy
2010.11.30, 03:42 PM
I did a 3 layer stack and only to find out later that it does not clear the chassis top cover left rear hole. How did you do yours? Thanks in advance.
http://i9.photobucket.com/albums/a65/dealerxing/Mini-z/IMG_0739.jpg
Mine is straight up like yours, so I had to cut the cover a lot. With the cover on, my fets are touching the under side of my disc damper and the screw to hold the disc damper down almost touches as well
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.