PDA

View Full Version : tire gluer needs new shims for 18mm wheels


hpgod
2011.01.29, 08:04 AM
Philip
You probable know this.
I glued up some 18mm front wheels last night. The tire/wheel slide right through the center the aluminum hold down clamp on the gluing rig. :(

Are you coming out with some new addon (red/Blue) shims with a smaller ID for the tire glueer?


Ps
I wish you would update the F1 motor mount so the shockmount was flush with the cross bar. The F1 works great with disk damoer there, My JB weld solution of cutting it off and jb welding back on runs great but fails if the car is dropped/extreme crashes.