PDA

View Full Version : Quick question on AR-265 MM motor pod


Skv012a
2011.02.21, 07:22 PM
http://www.egrracing.com/shop/dps-set-for-ar265-motor-pod-black-p-4356.html

So.... how does this DPS work exactly? Out of the packaging, I see no springs or a post mount....

Atomic-USA
2011.02.21, 09:34 PM
You need this: AR-265-BKDPS

http://www.egrracing.com/shop/images/medium/atomic/AR-265-BKDPS_m.jpg
*a single disc on top can be sufficient.


http://www.egrracing.com/shop/images/addition_atomic/AR-265-DPS_inst.jpg

or mount a conventional DPS on the forward two holes.

Skv012a
2011.02.21, 10:11 PM
I have both kits actually, but I'm not quite following where I should put the spring. Also, does the DPS post just hang under the metal plate?

Atomic-USA
2011.02.21, 10:53 PM
Look at the photos above and below you'll see where the spring goes. AR-275 v.3 springs are recommended:


http://www.egrracing.com/shop/images/addition_atomic/AR-265-DPS_inst1.jpg

AR-275
http://www.egrracing.com/shop/images/medium/atomic/AR-275_m.jpg

Skv012a
2011.02.21, 11:02 PM
Yea, figured it out. Very quirky design for sure.

Just want to note that the set screws for the metal plate were WAY too long and I had to cut them down for a perfect fit.