PDA

View Full Version : need measurments on aftermarket ball diff


TyHodge07
2011.03.15, 06:26 PM
I need some measurements from an aftermarket diff for the awd z. I need overall width than width from inside the oitdrive part to the other side. Than thickness and also main gear measurements. Preferable in cm. Thanks to whomever can help.

TyHodge07
2011.03.16, 05:19 PM
No one own a ball diff?

Bodom
2011.03.17, 06:44 AM
Can you draw on this picture (http://shop.tinyrc.com/d_images/ATO-AWD80-a.jpg) for example the measurements you need, as I can't get quite clear your description. And I'll measure my Atomic Ball diff. for you.

TyHodge07
2011.03.17, 12:03 PM
I use my evo. So hard to draw out. I'll explain best I can from the pic. Overall length from outside of outdrive hub to other outside of outdrive hub. Than inside of outdrive hub to the other inside if outdrive hub.

Than from pic ontop of the main gear where the silver washer is. Need thickness of that. And than where the hole is where u adjust need thickness of that end also. Basically to get an idea of how round. And finally the gear side to side not the little width(thickness) of it.

TyHodge07
2011.03.17, 01:10 PM
alright i got to a computer. the red lines, the yellow lines and the 1 white line. did different colors so it didnt all cross with the same color. hope this helps

http://img832.imageshack.us/img832/1222/diffi.jpg (http://img832.imageshack.us/i/diffi.jpg/)

Bodom
2011.03.17, 08:03 PM
This is Atomic ball diff:
http://i447.photobucket.com/albums/qq194/Bodom_photos/Mini-Z/diffi.jpg
I got a 3Racing diff too.
It's measures are the following:
A:28.0mm
B:10.6mm
C:15.1mm
D:9.5mm
E:14.3mm

Edit:
The 3Racing diff is the one from this picture:
http://i447.photobucket.com/albums/qq194/Bodom_photos/Mini-Z/P1020648Copy.jpg

TyHodge07
2011.03.17, 10:32 PM
Thanks so much. Very much help.