View Full Version : What should I do with my old AM board??

2011.05.12, 02:53 PM
I was wondering if there is anything you can do with an old AM board. I was thinking of putting it in a smaller scale r/c car, but i'm not sure how difficult this would be. I also though ogf buildin gmy own chassis from scratch, but I'm not really sure how the servo motor and POT work together. SO have you done anything interesting with your old boards?

2011.05.12, 03:15 PM
Door stop? :)

2011.05.12, 05:35 PM
is everyone running the 4.2 boards?

2011.05.12, 06:42 PM
ive converted an xmod with one of my 20-30 old am boards

2011.05.15, 10:13 PM
ive converted an xmod with one of my 20-30 old am boards

Hmmm.... I'm sure theres a thead around here somewhere for that. Post some up if you can.

2011.05.17, 10:26 PM
the AM board actually can apply almost for anything.
just add a small submicro servo (i use 9g just like on 250size heli), take the pcb off, then wire the pot and motor replacing the original.
then u're good to go.
i been using the AM board for replacing iwaver 05, xmods truck and my custom 1:28 crawler.
and they work juuust fine till today.
good luck.