View Full Version : Wheel bearings for pn low down knuckle?
Just got the knuckles today and put them on. Then I went to put my wheels back on and the bearings will not fit over the post. I'm using boca bearings and apparently they are to tight of a fit. I don't want to sand anything so what bearings will fit the PN steering knuckles.
PNracing
2011.05.26, 10:28 PM
Just got the knuckles today and put them on. Then I went to put my wheels back on and the bearings will not fit over the post. I'm using boca bearings and apparently they are to tight of a fit. I don't want to sand anything so what bearings will fit the PN steering knuckles.
Please check the knuckles size, should be 1.95 to 1.98mm, if bigger then 1.98mm, should be the items defect, please send back to where you buy this parts, they will be exchange to you.
I talked to a friend and he said he ran into the same problem with boca bearings and his. He said the reflex bearings fit perfect so I ordered some of them to tryout first. If they also don't fit I will return them. Thanks for the reply though.
I actually have a few questions I would like to ask you. I'll send a PM later.
Thanks for the reply,
Well I just went and tried some new boca bearings and they slid right on. For some reason my 2 inside bearings were smaller then the rest of the bearings I had. The outside ones fit fine and so did all of the other bocas I have.
Your message box is full, so I guess no PM for you. I was really just wanting to ask a few questions about switching to the tri shock system from the disk damper.
color01
2011.05.26, 11:18 PM
Ask away! :)
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.