PDA

View Full Version : Brake Trigger for EX-1, part# 16061


dgomes
2011.08.30, 07:10 PM
Hello,

Does anyone know what this is for and how it works?

Thank you in advance!

Best regards,
Daniel

KO PROPO Staff
2011.08.31, 03:42 PM
Hello,

Does anyone know what this is for and how it works?

Thank you in advance!

Best regards,
Daniel

That is the old part number for the EX-1 Mars series. The newer part number is 84006.

The new part number is reflective of the new resin material used for this part. This is the same trigger that comes on the EX-1 UR.

-Robert

greenepa76
2011.08.31, 03:45 PM
Hi Robert,

Is the trigger assembly itself with the Potentiometer available? If so, what is the cost of the whole assembly? Mine is cracked on the throttle pin where it slips on the POT shaft.

KO PROPO Staff
2011.08.31, 04:19 PM
I have one complete EX-1 assembly available. The only thing that it does not include is the wiring that you have to solder to the pot.

This is a service item only so you would have to contact us to purchase this. The cost is $21.00 plus shipping. Once installed you have to do the Adjust Volume function to re-calibrate the pots in the transmitter.

Or you can send in the Tx for service and have it installed and the entire Tx checked over. Labor cost is $20.00 and is a flat fee for any repair performed to the Tx. This excludes parts used and shipping back to you.

greenepa76
2011.08.31, 04:44 PM
Ok, thanks. I'm down the street from you guys. Well, about 3 miles away.

KO PROPO Staff
2011.08.31, 05:59 PM
Ok, thanks. I'm down the street from you guys. Well, about 3 miles away.

Just give us a call if you want to stop by.