PDA

View Full Version : x-mod/mini-z bearings


rock hard
2011.09.28, 03:37 PM
Just curious,did a couple of searches and came up empty.

Will any of the bearings from a mini-z swap into a x-mod?

thestug
2011.11.15, 11:09 AM
I don't think so. The only bearings that come close are the bearings that go onto the Mini-z AWD diffs. They are a but wider than the x-mod bearings and might work in a pinch. If you are looking for bearings for an x-mod you could always look up the bearing sizes and buy the bearings on ebay because bearings come in standard sizes.

color01
2011.11.15, 04:48 PM
Mini-Z uses the same bearings in the knuckles as the Gen 1 Xmod. 3x6x2mm. :)

thestug
2011.11.15, 07:15 PM
Mini-Z uses the same bearings in the knuckles as the Gen 1 Xmod. 3x6x2mm. :)

crap. you are right. I completely forgot about the gen 1s. I was thinking back to my old evo.