PDA

View Full Version : PCB MR03 domage


vincentimes
2011.11.12, 08:38 AM
Hello!
I have a board to damage. I want to redo track(runway) to tear away(extract).
Can you say to me where I have to recover to redo the contact?
Thank you!http://img256.imageshack.us/img256/9927/pcbps.jpg

Action B
2011.11.12, 09:52 AM
Hello!
I have a board to damage. I want to redo track(runway) to tear away(extract).
Can you say to me where I have to recover to redo the contact?
Thank you!

http://farm7.static.flickr.com/6037/6336884443_6598907799_b.jpg

Here is the closest locations. I'm going from memory so you may want to verify the trace on the blue one as I'm not at home to double check.

For "B" I would jumper straight over to the blue circle. For the "A" personally I would use the FET leg on the other side. I can provide a picture of the exact one when I get home to my stuff this afternoon. If you feel gutsy and are fairly skilled you can try pulling the button and going for the orange circle to extend the trace over to the FET leg.

PS. Both are SIGNAL circuits so you don't need to worry that much about the size of the wire or amount of solder, if you can make them connect your generally good to go.

vincentimes
2011.11.12, 01:20 PM
thank you very much!
I am going to make the following modification.
I hold you informed about the result(profit).
Still thank you!