PDA

View Full Version : PN50T on 3004?


tudor_47
2013.10.14, 02:31 AM
wondering will the 27Mhz board 3004 fets be strong enough for the PN50T ballbearing motor?

briankstan
2013.10.14, 10:25 AM
wondering will the 27Mhz board 3004 fets be strong enough for the PN50T ballbearing motor?

it should be fine as long as you are not over geared for it. that will cause to much draw and will pop the single layer 3004 fet.

tudor_47
2013.10.18, 02:26 AM
funny, that is exactly what happened, I have now replaced the 3004's with a layer of 8858 so It should now be OK.