PDA

View Full Version : Mr02ve


r46
2014.08.22, 03:56 PM
02VE CONVERT
my first mini z has taken on another transformation

beta stage:
remove old 2.4 board to check size difference an make template for port opening in top deck

http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG_20140713_182343_zpsm4qwwdgo.jpg

soldered steering pot an servo motor to board, bypassed switch

http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG_20140713_185908_zpst8mg8hrp.jpg

made opening for ics/ transponder port

http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG_20140714_004853_zpsh6at4njm.jpg

http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG_20140714_005042_zpsrpli7r6j.jpg

TheSteve
2014.08.22, 04:00 PM
Nicely done!

If you like the power switch at all there is no need to bypass it with the VE electronics as motor power does not pass through it.
Which transmitter with you be using it with? You will need to extend the steering endpoints to get lock to lock steering, you may always want/need to add some transmitting mixing to prevent a loss of signal.

r46
2014.08.22, 04:04 PM
As kidnapped it's reflex mount for hfay chassis, got a pn multi mount for it an atomic motor
http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG-20140809-WA0061_zps08mjdd0t.jpg

http://i1112.photobucket.com/albums/k498/raceruo09/Mobile%20Uploads/IMG-20140809-WA0063_zpsbwuuslpg.jpg

Waiting on sp chassis, pn gear diff to arrive

r46
2014.08.22, 04:09 PM
Nicely done!

If you like the power switch at all there is no need to bypass it with the VE electronics as motor power does not pass through it.
Which transmitter with you be using it with? You will need to extend the steering endpoints to get lock to lock steering, you may always want/need to add some transmitting mixing to prevent a loss of signal.

I use ko helios & Mars R

TheSteve
2014.08.22, 04:18 PM
Once you get it all adjusted to your liking see if the LED on the VE chassis flickers at all with fast right/left steering transitions.

herman
2014.08.22, 10:07 PM
nice conversion... question did you use the mr02 servo or the mr03 servo? if you used the 02, how did you solder the 3 wires to the pot? if 03 how did you secure the servo motor? i think the 02 & 03 servo motors are quite different...

thanks for any reply... thanks for sharing too... nice conversion...

r46
2014.08.23, 02:46 AM
nice conversion... question did you use the mr02 servo or the mr03 servo? if you used the 02, how did you solder the 3 wires to the pot? if 03 how did you secure the servo motor? i think the 02 & 03 servo motors are quite different...

thanks for any reply... thanks for sharing too... nice conversion...
:)
using orignal(02) servo motor straight forward install onto board ;) (as this z was 27mhz then 2.4ghz doing the ve conversion was a breeze)
yes theres a big difference between 02 & 03 servo motor

herman
2014.08.23, 05:21 AM
oh ok thanks for the info...