PDA

View Full Version : Tri Damper plate question


Mania
2014.12.08, 03:46 PM
I didn't want to revive the 3 year old tri damper thread, so I am posting my question here:

I am currently running the MR2994C tri damper setup for 94mm with the MR2995 motor mount, MR2161 dual spring center shock, and MR2061 disc damper.

http://www.kenonhobby.com/assets/images/MR2994C.jpg

http://www.kenonhobby.com/assets/images/mr2295-v3-s.jpg

However, I would like to try running this setup in 98mm. From what I can tell, the only new part I would need is this, the MR3399G damper plate, correct? It appears to be very similar as the damper plate I am using, except it has an extra set of holes allowing me to set the motor pod further away. It also looks like if I use the inner set of mounting holes I can also use the plate at 94mm. Can anyone confirm this for me?

http://www.kenonhobby.com/PN-Racing-Mini-Z-Tri-Damper-System-98mm-Damper-Plate-Black_p_45474.html

Alternatively, would this Reflex Racing plate RX1168 work in the same way? I am using the PN racing dual spring center shock and I am uncertain if that will fit properly, as well as allowing me to use both a 94mm and a 98mm (PN-based) tri shock setup.

http://www.reflexracing.net/assets/images/large%20images/rx1168.jpg

yasuji
2014.12.08, 06:18 PM
I didn't want to revive the 3 year old tri damper thread, so I am posting my question here:

I am currently running the MR2994C tri damper setup for 94mm with the MR2995 motor mount, MR2161 dual spring center shock, and MR2061 disc damper.

http://www.kenonhobby.com/assets/images/MR2994C.jpg

http://www.kenonhobby.com/assets/images/mr2295-v3-s.jpg

However, I would like to try running this setup in 98mm. From what I can tell, the only new part I would need is this, the MR3399G damper plate, correct? It appears to be very similar as the damper plate I am using, except it has an extra set of holes allowing me to set the motor pod further away. It also looks like if I use the inner set of mounting holes I can also use the plate at 94mm. Can anyone confirm this for me?

http://www.kenonhobby.com/PN-Racing-Mini-Z-Tri-Damper-System-98mm-Damper-Plate-Black_p_45474.html

Alternatively, would this Reflex Racing plate RX1168 work in the same way? I am using the PN racing dual spring center shock and I am uncertain if that will fit properly, as well as allowing me to use both a 94mm and a 98mm (PN-based) tri shock setup.

http://www.reflexracing.net/assets/images/large%20images/rx1168.jpg

With the 2 top pictures every thing is there to run 94/98 set up94 is the forward position and 98 would be the rear position the same for the dual shock

Mania
2014.12.08, 10:54 PM
Oh, sorry my bad but this is the plate I am currently using, not the one in that picture.

http://www.kenonhobby.com/assets/images/MR2994G.jpg

yasuji
2014.12.09, 08:46 PM
This is what u will need

Mania
2014.12.09, 10:04 PM
Thanks! I see there is now a picture in the product page too - that's good!