PDA

View Full Version : Scorpion Z Series Z-1410-6000KV


arch2b
2014.12.30, 12:20 PM
does anyone have documentation for wiring alignment for this motor? also looking to find out what bullet connectors are used? these fit well with stock kyosho receiver ends.

the motor leads are all black and the end bell doesn't have any markers for the typical A, B and C.

LED
2014.12.30, 12:58 PM
does anyone have documentation for wiring alignment for this motor? also looking to find out what bullet connectors are used? these fit well with stock kyosho receiver ends.

the motor leads are all black and the end bell doesn't have any markers for the typical A, B and C.

What exactly do you need? Just connect it. If turns the wrong way swap 2 of the 3 wires. You cannot do something wrong with mixing up wires.

arch2b
2014.12.30, 01:39 PM
Good to know. Would have been nice for them to provide some indication though.

El Tigre
2014.12.31, 08:23 PM
I think that if its sensor less than it does not matter what is connected to what.