View Full Version : Drilling Kyosho BL motors...

2017.06.18, 06:38 PM
Can anyone chime in with their success stories about drilling kyosho bl motors for mounting to aftermarket motor pods and whether or not anyone has an exact depth for their drill bit work?

I have access to a drill press so i'd like some exact measurements to avoid drilling into the wind structure.

2017.06.23, 10:43 AM
Hi click on atomic collective in my signature. Was fortunate to see the mr03 ve as it was just being released in Singapore... one of Singapore's top drivers and super cool guy, Dave Tang was up to the task... he immediately drilled a hole in the bl motor. I asked him how did he do it... he just replied "very carefully"... the short of it is that it can be done...
Hope this hhelps