PDA

View Full Version : Rules: 70 Comp


GIHOSU
2019.03.02, 09:25 AM
Dimensions:
Width: 82mm max.
Length: 200mm max
Height: 70mm max
Chassis:
Open, 86-102mm wheelbase
Electronics:
Open, blinky mode operation (no advanced timing)
Motor:
Brushed 70t 130 or 130 sized 3500kv brushless motor
Gear limit:
3.6 final drive ratio (14/51, 12/44)
Battery:
4xAAA NiMh Batteries
Body:
Mini-Z compatible purpose built hard body (Kyosho, TRP, Jomurema, Iwaver, GL...)
Lexan window permitted. Bodies may be altered for wheelbase but a maximum wheel opening of 31mm measured horizontally. Wheel wells may be altered for tire clearance but the body must cover the tire viewed from above. Headlight buckets may be omitted but lens must be in place (or covered by decal). Taillights may be removed. The rear bumper may be cut but no higher than 18mm from the chassis bottom . Holes are legal in the remaining fascia. Small body parts may be omitted. Front splitters and body sides may be trimmed for track clearance.
Wing:
All wings original to the body are legal. Aftermarket or non original wings must not extend higher than roof line relative to chassis bottom plane (excluding extensive roof scoops, for example Kyosho NSX) or past widest point of body. This includes all parts of wing (side dams, etc...).
Performance option part:
Open
Wheels:
Any Mini-Z type wheels, plastic or aluminum.
Front: 9 x 22mm max
Rear: 11 x 22mm max
Tires:
Rubber tire of any company, no silicone or foam