Mini-z steering servo 4 leads?
Hey folks,
I'm going to use a mini-z PCB and motor for a little custom project of mine. However, i'll be using a regular steering servo. How does the mini-z 4-leads relate to the normal 3-leads on my futaba and hitec servos? Many thanks, Ørjan I guess I haven't signed in a while.... good thing nobody tried to get hold of me ;) "Welcome, osandlan. You last visited: 2003.11.09 at 04:30 AM Private Messages: Unread 0, Total 0." |
Follow the pictorial here for converting standard servos to Mini-Z, it should explain everything. The only difference is that ASF Mini-Z's have 3 wires going to the potentiometer (black cylinder), while your Mini-Z only has 2 wires going to the pot -- the other 2 go directly to the steering servo motor.
http://www.kimihiko-yano.net/Product...ni-z-servo.htm Hope this helps. :) |
That was pretty neat, and google translate did actually help too :)
Question is though - how to handle having "only" two leads to the potentiometer? The pcb will come from an upgraded MR-015. Using a new ASF board is a bit too expensive I think. Thanks again. Ørjan |
All times are GMT -5. The time now is 10:09 AM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2011 Mini-ZRacer.com