Mini-Z, Kyosho Mini-Z Racer, MR-03, MR-02, MA-010, Forums, News, Pictures, Parts, and Shop - Mini-ZRacer.com
Forums, Mini-Z, MiniZ, Kyosho Mini-Z, Kyosho MiniZ, Kyosho Mini-Z Racer
Mini-Z Hop-Ups, Mini-Z Parts, MiniZ Hop-Ups, MiniZ Parts, Kyosho Mini-Z Hop-Ups, Kyosho Mini-Z Parts, Kyosho MiniZ Hop-Ups, Kyosho MiniZ Parts, Kyosho Mini-Z Racer Hop-Ups, Racer Kyosho Mini-Z Parts

Go Back   Mini-ZRacer.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: mleemor60
Forum: Custom Bodies 2017.11.18, 08:21 PM
Replies: 6
Views: 43
Posted By mleemor60
The only LM body that I recall having height...

The only LM body that I recall having height issues was the Sauber Mercedes. Some were really jacked up in the rear and some needed to have bubble created in the rear above the spur to keep it from...
Forum: New York Mini-Z Racing 2017.11.09, 02:45 PM
Replies: 11,662
Views: 511,823
Posted By mleemor60
Bruckner in Queens I believe.

Bruckner in Queens I believe.
Forum: Batteries, Chargers and Dischargers 2017.10.30, 02:00 PM
Replies: 6
Views: 141
Posted By mleemor60
It isn't necessary to have the fan blow down onto...

It isn't necessary to have the fan blow down onto the batteries. Just set the fan beside the charger so it blows air across the cells during charging thereby carrying the heat away. I use one fan to...
Forum: Batteries, Chargers and Dischargers 2017.10.29, 10:28 AM
Replies: 6
Views: 141
Posted By mleemor60
I have never used anything except the Lacrosse...

I have never used anything except the Lacrosse chargers for ten plus years. They will shut down thermally when a temperature of 128* F is reached. To stop this from happening I run a 6" 110V case fan...
Forum: Beginner Questions 2017.10.25, 01:03 PM
Replies: 8
Views: 205
Posted By mleemor60
At the top of the forum page you will see a tab...

At the top of the forum page you will see a tab named shop. That is our benefactor, Tiny RC.com. Though they are decently stocked they may not always have available what you need so go there first....
Forum: Beginner Questions 2017.10.25, 10:57 AM
Replies: 8
Views: 205
Posted By mleemor60
First, welcome to the forum. Sounds like another...

First, welcome to the forum. Sounds like another that has stumbled into Bruckner.

Of the two cars you linked the second one is the best candidate. The gyro is a nice touch for shoveling...
Forum: General Discussion 2017.10.19, 05:10 PM
Replies: 5
Views: 187
Posted By mleemor60
Just remove the steering wheel and put it in the...

Just remove the steering wheel and put it in the box. That will save you a lot of space.
Forum: Custom Bodies 2017.10.16, 11:56 AM
Replies: 7
Views: 95
Posted By mleemor60
Tooth polish would be best. Something like "Pearl...

Tooth polish would be best. Something like "Pearl Drops". Polishing compound not rubbing. Maybe some 2000 grit sandpaper. Anything to minimize the scratches to the surrounding area.
Forum: Transmitters, Receivers and Crystals 2017.10.15, 03:44 PM
Replies: 17
Views: 3,673
Posted By mleemor60
Ah yes, the old "hokey-pokey"!

Ah yes, the old "hokey-pokey"!
Forum: Mini-Z Science 2017.09.13, 06:16 PM
Replies: 6
Views: 144
Posted By mleemor60
In my opinion the "standard" will remain to be...

In my opinion the "standard" will remain to be the 03ASF brushed for a few more years. The swelling of VE from Kyosho created an instant aftermarket for the plethora of different chassis from many...
Forum: Mini-Z Science 2017.09.13, 03:01 PM
Replies: 6
Views: 144
Posted By mleemor60
Currently on the "bay" item number122667111815 is...

Currently on the "bay" item number122667111815 is a short cut to your destination. It is already equipped with the extremely rare 901SM module so it is ready to handle the early 02 ASF, 03ASF and...
Forum: Mini-Z Science 2017.09.12, 01:33 PM
Replies: 6
Views: 144
Posted By mleemor60
Other than the difference in servo motors, no....

Other than the difference in servo motors, no. You should be able to use the 02 servo motor and just solder it to the board.
Forum: Mini-Z AWD MA-03F 2017.09.11, 07:12 PM
Replies: 31
Views: 737
Posted By mleemor60
Haven't they already gotten in the sack with...

Haven't they already gotten in the sack with Flysky? The KT432 and the It-4 are literally identical with the exception of the switchable chassis for lefty's and of course the additional protocol.
Forum: Motor Tech 2017.07.13, 05:01 PM
Replies: 5
Views: 286
Posted By mleemor60
Just off the cuff I would say the PN 70T with CS...

Just off the cuff I would say the PN 70T with CS brushes. The VE has more overall speed but lacks braking control while the 70T gives up a bit of top end but has much more overall control. Check with...
Forum: Beginner Questions 2017.06.20, 07:58 PM
Replies: 9
Views: 871
Posted By mleemor60
Where are you located, geographically? I ask...

Where are you located, geographically? I ask because it may be possible to steer you in the direction of an existing group that can take you in hand and guide your progress.

Welcome to the forum.
Forum: 2.4GHz ASF System (Auto Selected Frequency) 2017.05.06, 07:15 AM
Replies: 6
Views: 435
Posted By mleemor60
Just for sh1ts and giggles, check to see what if...

Just for sh1ts and giggles, check to see what if any transmitter adjustments pertaining to steering strength or gain there are. if you have adjustments try backing them down and raising the board...
Forum: 2.4GHz ASF System (Auto Selected Frequency) 2017.05.04, 03:28 PM
Replies: 6
Views: 435
Posted By mleemor60
Red Bull disease! Common in early ASF boards. Get...

Red Bull disease! Common in early ASF boards. Get a hold of the setting card for the 03 board and reduce the gain on the steering servo by a notch or two. That should take care of it.
Forum: Transmitters, Receivers and Crystals 2017.05.04, 06:41 AM
Replies: 4
Views: 498
Posted By mleemor60
I would think that the first thing to do is...

I would think that the first thing to do is select the transmitter. Once done then proceed to receiver choices. Though I have not experienced it, I have heard of range issues with the Das Mikro units...
Forum: Transmitters, Receivers and Crystals 2017.05.02, 02:10 PM
Replies: 4
Views: 498
Posted By mleemor60
If you are working with a "sports" series Mini-Z...

If you are working with a "sports" series Mini-Z chassis then the IT-4 or Kyosho 432P transmitter will bind directly with the chassis. Either radio has separate protocols for FHS and FHSS.
Forum: Mini-Z Marketplace 2017.04.29, 06:48 AM
Replies: 2
Views: 305
Posted By mleemor60
Bump it up.

Bump it up.
Forum: Mini-Z Marketplace 2017.04.28, 10:14 AM
Replies: 2
Views: 305
Posted By mleemor60
Anyone? Anyone?

Anyone? Anyone?
Forum: Mini-Z Marketplace 2017.04.27, 02:51 PM
Replies: 2
Views: 305
Posted By mleemor60
WTB MZH-303BK wheels

Looking for the 303BK wheels or the front and rear wheels from any of the Sauber Mercedes ASC's.

Contact via PM
Forum: AMR Mini 2WD Touring Car 2017.03.24, 12:30 PM
Replies: 48
Views: 4,222
Posted By mleemor60
The ones that I have are ASF.

The ones that I have are ASF.
Forum: Transmitters, Receivers and Crystals 2017.02.26, 05:14 PM
Replies: 33
Views: 4,153
Posted By mleemor60
Marwan, do you have a Euros radio? I don't...

Marwan, do you have a Euros radio? I don't remember. if you do I have a 902SM module available. I just picked up a 4PKS so maybe we can work something out.
Forum: Events 2017.02.21, 12:56 PM
Replies: 25
Views: 636
Posted By mleemor60
The original set of RCP rail liners worked pretty...

The original set of RCP rail liners worked pretty well and could stand being stepped on. The biggest issue with them came when somebody bounced off and back into traffic it created a 7-10 split with...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 01:33 AM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2011 Mini-ZRacer.com
Mini Inferno Sale - Up to $85 Instant Savings!
Micro-T Hop-Ups
RC18R, M18, Micro RS4, Mini-LST, TamTech-Gear, Minizilla, RC18T, RC18B, RC18MT
shop.tinyrc.com Products

more»
Tiny RC Community News
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated. The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year.  Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All! Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»
Mini-Z, Mini-Z Racer, MR-02, MA-010
M18, M18T, RC18T, Mini-LST, Mini-T, Micro RS4, XRay, 1/18, 18th scale
XMODS, XMOD, Micro Flight, ZipZaps, ZipZaps SE, Bit Char-G, MicroSizers, TTTT, Plantraco Desktop Rover, SuperSlicks, Digi Q
Mini Inferno, Mini Inferno ST, half EIGHT, 1/16, 16th scale
Epoch, Indoor Racer, 1/43, 43rd scale
E-Savage, eSavage, eZilla, e-Zilla, HPI
Robots, Bots, Bipeds, Wheeled, Manoi, Roomba, NXT, Lego, Hacking
Crawling, Crawlers, Micro, RC, Losi Mini-Rock Crawler, Duratrax Cliff Climber
Kyosho Minium, Caliber 120, Minium Forums
Mini-Z Hop-Ups, Mini-Z Parts, Mini Inferno Hop-Ups, Mini Inferno Parts, M18 Hop-Ups, M18 Parts