View Single Post
Old 2002.08.27, 07:41 PM   #14
Russ
Super Moderator
 
Russ's Avatar
 
Join Date: Nov 2001
Location: Atlanta, GA
Posts: 1,448
Send a message via AIM to Russ
Even though they may look it, 99% of the H plates made aren't 100% flat all around. Even if they are, the weight balance from the motor throws it off too. It is highly unlikely that you have the perfect setup right out of the box. So, yeah, your H bar is probably bent, or tweaked a little, you know, twisted a bit. You have to compensate for that little twist.
__________________
Russ

--------------------------------------------
Russ is offline