View Single Post
Old 2013.12.06, 10:57 PM   #3
imxlr8ed
Registered User
 
imxlr8ed's Avatar
 
Join Date: Sep 2004
Location: Reading Pa.
Posts: 4,124
What is up dude!?! Been a long while, hope all is well!

I didn't even know there were other camber parts for the F1... Learn something everyday! Yes, the toe does and will have to change for initial setup, if you stick with a zero rod your toe in at 2 degrees knuckle camber will increase a bit. My F1 tie rod set should be able to address this nicely.

I'm basing this design on what my Jordan has done since I modified it and I' really hoping it gets the same effect without having to do all of that sloppy heating and bending. My initial design was an upper type system but it just didn't seem to make sense once I got modeled and moving on the screen. It seems to be a much sturdier system when it's on the bottom.

If you ever get out our way, you're always welcome here to get that dust off those cars!
__________________
My Online Design Studio and Shop!

http://www.shapeways.com/shops/UID

http://www.howfastareyou.com

SUPPORT LBR!!!
(Local Basement Racing)
imxlr8ed is offline   Reply With Quote