View Single Post
Old 2013.12.16, 09:12 PM   #14
arch2b
Moderator
 
arch2b's Avatar
 
Join Date: Sep 2002
Location: Washington, DC
Posts: 35,480
Send a message via AIM to arch2b
the stock spacer is too short.

the bearing isn't the issue. the overhead picture was with the stock spacer only. if you look closely at the rear picture, the ball post is still plumb despite the bearing not sitting flat. it's only turned down hand tight, not cranked down. i do need to find a couple really thin shims that are smaller diameter to flatten that out though. I'm still mocking it all up at this point, nothing is final.

Last edited by arch2b; 2013.12.16 at 09:15 PM.
arch2b is offline   Reply With Quote