View Single Post
Old 2010.11.22, 09:40 PM   #16
mdowney
Pew-Pew!
 
mdowney's Avatar
 
Join Date: Jul 2010
Location: Seattle, WA
Posts: 215
Quote:
Originally Posted by EMU View Post
As said above, Futaba does not make a servo for the Mini-Z. The servo is integrated in the chassis, and driven by the Mini-Z circuit board. In the case of the P28 and MRCG, when using the Mini-Z electronics, they use the case/motor and gears of the Futaba servo, but are driven off the Mini-Z circuit board.

If you ever want to use high end electronics on the Mini-Z, you would need a receiver, speed controller and servo controller (wired to the integrated servo motor and potentiometer).

Hope this info helps...
OK - gotcha. This is all starting to make a lot more sense now. Thanks guys!
mdowney is offline   Reply With Quote