View Single Post
Old 2019.03.28, 08:16 PM   #3
Smokey_truck
Guest
 
Posts: n/a
Quote:
Originally Posted by EMU View Post
You need to run 3 wires. AM used an analog arrangement with 2 wires, where the ASF uses a more precise digital arrangement. When you wire it up, if the center wire (wire 2) goes to the 2nd pad on the board. Wire 1 and 3 go around it. If the servo pulls away from center, then reverse wires 1 and 3 and servo will center. Then reverse the steering channel if needed. If steering is reversed and you do not want to reverse the steering on the radio, you would need to swap wire 1 and 3 as well as the servo motor wires.

Hope this info helps.
Thanks EMU, initially I wired that way, unfortunately the servo motor kept running, after disconnected the wire it stopped. So I bridged the middle one and one side of the pot. Not sure why servo motor is running without doing anything on the controller when 3v is connected to one side on the POT. Any ideas?

Smokey
  Reply With Quote