On the side of the motormount, there are 3 screws, 2 to adjust the mesh of the motor to the diff, and one to adjust the height of the damper post mount. Loosen the screw that goes to the damper post mount and let it settle so that both springs on the disc damper are even (I usually like the lower spring to be slightly compressed) then tighten the screw again.
If the ride height is off, then you can adjust that by changing the bearing holders in the motormount. It comes with 2 sets, one for 0 and one for 1mm adjustment (either up or down depending on the orientation).
__________________
EMUracing
Micro RC Syndicate /DG Designs /GSR /Reflex Racing /Fast By Faqish /MurderTown Racing
|