well, what happened prior to my attempt to re-solder was when there was no motor connected, the steering would work and when i hit the throttle, the board would NOT die. once i would connect a motor, and hit the throttle (in noob mode - flashing LED on the controller) there would be no response from the motor, and the LED on the board would die and there would be no response at all, until i would reset the batteries.
Now that I have re-re-soldered the capacitor, the board no longer dies with the motor connected when i hit the throttle, although there's no response from the motor. I tried this with two motors.
any ideas?
|