View Single Post
Old 2012.02.22, 06:52 AM   #1
Fovea3d
Registered User
 
Fovea3d's Avatar
 
Join Date: Feb 2002
Location: Strasbourg France
Posts: 757
Mini-z body Shara

Received the first print of the Shara. The model is perfect and needs no editing.

- Low and ultrawide body! Needs a LM axle and largest wheel offset
- blower with air scoop and rear fake chassis are included but mount is optional for weight saving.
-Tested on a MR03 chassis stock (x-speed). Very stable and "square" behaviour. Rounded front nose will slide on obstacles. No rear overhang at all. Side body clip area very rigid due to the presence of the side air intakes (same effect as the Enzo body). Large side air intakes and rear openings will keep the motor cool.

Specs.

For MR02-03W. Needs a LM axle for correct widdness
wheelbase 98mm
+3F/+4.5R
Weight 17.8gr without snap-on accessories

Link

Pictured with Tagus +4.5 rear and +2 front (I don't have +3 Tagus 5 spokes).










Feel free to post your own realisations here. This thread is also open to requests for improvement of this body.
__________________
3d printed bodies and parts
mini6z
European mini-z forum
My mini-z collection

Last edited by Fovea3d; 2012.02.23 at 11:27 AM.
Fovea3d is offline   Reply With Quote