I have a question about setup and a few comments on this product:
In the build directions, the knuckle gets installed with the short pole of the knuckle pivot axle on the bottom side. I haven't tested yet but under bench test compression I can pop the knuckle out of the lower pivot ball housing. I notice as well that the long section of the knuckle pivot axle is installed top side where the length seems to be less of an issue....
Have I installed the knuckle incorrectly? Are my bench test compressions falsely popping the knuckle out (Am I going overboard?)
My only comment about this product (other than the comment/question above) is the extremely fiddly nature of installing the steering pins on the knuckle. If you plan on making something that requires very careful work you might consider a tool to go with the kit or a change in the shape of the install surface so it fits a nut driver. That'd ensure a smoother install.
|