View Single Post
Old 2017.03.09, 03:46 PM   #4
Mughal86
Registered User
 
Join Date: Feb 2017
Posts: 7
I have Just installed the Kyosho motor heat sink and aluminum plates on my buggy. I am using Atomic 48t standard motor. Upon installing the new option parts I noticed that the Heat sink when fully seated to the chassis creates too tight of a gear mesh. In the instruction manual it says to back out the screws 90 degrees if the mesh seems to tight. I had to back out the screws at least 720 degrees to get the buggy to roll better and not bind. Is this normal? I noticed that the aluminum plates came with 3 different size motor holders( 6.0, 6.1, and 6.2). I used the 6.2 at first and the problem was worse. I tried the 6.1 and it is better. The 6.0 does not fit on the motor. The plastic Heat sink seems to fit perfectly fine and the screws sit flat on the chassis, with the Aluminum motor heat sink I have to back out the screws quite a bit. Is this normal?
Mughal86 is offline   Reply With Quote