View Single Post
Old 2010.01.06, 10:54 AM   #12
pedrocamp
Ain'tSoldEm
 
Join Date: Jul 2006
Location: Mooresville, NC
Posts: 860
Camber gain is dependent on the angle of the upper arm. Raising the axle on the knuckle doesn't change the upper arm angle, only lowers the chassis relative to the axles. You could change camber gain by shimming on top of the knuckle but you need correspondingly shorter springs (or remove shims underneath it if available) to get the ride height back.
pedrocamp is offline   Reply With Quote