View Single Post
Old 2017.09.23, 12:38 PM   #1
Registered User
Join Date: Sep 2007
Location: Piteň, Sweden
Posts: 4
Swap pcb mr02lm > ma010?

Is it possible to fit a mr02LM board in my ma010?


After help from the people in this forum I came it down to this...

If you want to fit a Mr02lm board onto a Ma-010/015 you need to do the following:

*replace/extend battery wires.
*Extend 1 servo motor wire.
*Extend on/off-switch wires
*Reverse polarity on the servo motor

Last edited by Gadd; 2017.10.06 at 07:07 PM.
Gadd is offline   Reply With Quote