View Single Post
Old 2010.10.04, 11:25 AM   #74
banquer
Registered User
 
banquer's Avatar
 
Join Date: Nov 2006
Location: Granada (Spain)
Posts: 48
Quote:
Originally Posted by john-lam View Post
Hi:

1) you mean disconnect the led, it means the led should be taken out from the 901sm pcb board?
Yes, thats right!

Quote:
Originally Posted by john-lam View Post
2) During paring with the mini z car, Should i need to hold the pairing button
on the car PCB board and at the same time connect the pin on the 4pk for five seconds and then disconnect it


it would be appreciated if you can help me clarify these two things

thanks one more time
In this order.
1st. plug red and green wires from 4PK.
2nd. Turn on the 4PK.
3rd. Count five seconds.
4th. Unplug red and green wires.

Now the the 4PK is in 901SM paring mode.

Turn the miniz on with the pairing switch on. When miniz led goes on, release switch. Led must be on. If wright then turn off the miniz and the 4pk. If not repeat the proccess.
Dont forget to put 4PK in normal mode and C1 emission mode. And turn on to DISP mode (this is the mode that the 901SM run).

They are sincronized!

King regards!
__________________
Club Deportivo Micro RC Granada
http://www microrcgranada com
Futaba 4PK and KO901SM inside!
Kyosho MR03 Ferrari F430
Kyosho MR03 Mercedes C9
banquer is offline   Reply With Quote