View Single Post
Old 2003.07.31, 05:43 PM   #5
screaminduck
Chick Magnet
 
Join Date: Feb 2002
Location: Northern Cambria, PA
Posts: 40
I'm betting there is a good chance one of the 4 wires that run from the circuit board into the front servo case is broken or just about broken. Mine did the exact same thing. Mine were broken on the circuit board side, right where they connect to the board. Those wires aren't very flexible and from twisting and turning it trying to resolder it two more of the wires broke off. After resoldering them they end up just a hair shorter and mine came real close to interfering with the suspension travel after it was all back together. Longer more flexible wire would be a good idea if you have any.
screaminduck is offline   Reply With Quote