View Single Post
Old 2013.02.08, 01:48 PM   #5
TheSteve
VE7FM
 
Join Date: Oct 2010
Location: Langley, BC
Posts: 629
When you read/write the ICS data are you reading and writing specific bytes or is there an entire block of eeprom data?

I also assume different cars have unique bits/bytes to indicate the model of car - MR03, MR03 with chase mode etc.

The reason I ask all of this is when you swap an MR03 board into an AWD the steering throws are incorrect because the values from the servo pot are different. The different models must have a table or different programming to indicate the proper endpoints. I am wondering if its hard coded in flash or set via values in the eeprom, and if it is in the eeprom I am wondering if it could be altered via the ICS port (even if not intended to be by Kyosho)

If it could be changed then boards could be swapped between different car models without worrying about steering throws incorrect.
TheSteve is offline   Reply With Quote