View Single Post
Old 2009.12.05, 12:53 PM   #7
arch2b
Moderator
 
arch2b's Avatar
 
Join Date: Sep 2002
Location: Washington, DC
Posts: 35,480
Send a message via AIM to arch2b
1. please post to an appropriate area. kyosho is not the best place for a discussion on atomic knuckle issues.

2. DO NOT POST THE SAME TOPIC MULTIPLE TIMES.

every brand lets a few bum units out. i've had pn parts that had milling flaws, angled taped holes or holes not tapped. atomic and pn have been more consistent for me than 3racing and gpm.

yes, i've had the same issue with pn knuckles even. it's either shaft tolerances or bearing tolerance issue. i just changed out the bearing and moved on. odd thing is, it's only happened with a couple bearings. maybe 4 out of 12.

you could try polishing the shaft to remove the smallest fraction of material or contact the retailer and or manufacturer for a replacement or refund. no point in keeping a bum part.
arch2b is offline   Reply With Quote