Quote:
Originally Posted by Mike Keely
If you keep the same amount of shims on both sides it should have the same amount of camber on both sides.
|
That is the problem! To get the same camber, I need to shim more on one side.
Quote:
Originally Posted by Mike Keely
It is the length from the pivot pin to the kingpin ball.
|
That is what I wanted to know. I put a 0 deg and 2 deg arm side by side and it was hard to see, but the 0 deg arm was a little longer from pin to ball than the 2 deg arm.
Guessing one of the 2 deg arms I have has a little more bend in it than the other. Wonder if there is an easy way to measure that and get them equal, instead of installing them on a car and shimming them equally.
Wonder if I can somehow use the Reflex Racing camber key tool to compare them.
Quote:
Originally Posted by Mike Keely
Hope this helps.
|
Thanks for your help!