View Single Post
Old 2018.10.08, 12:25 PM   #1
TPDazzle
Registered User
 
Join Date: Oct 2016
Location: Tri-Cities, WA
Posts: 207
Soldering Brushless motor wires

I am totally new to brushless. I just got a PN 5500 v2 motor. I understand that there are 3 wires and which one goes where.

My question is: Do I solder them to the 3 little u-shaped bracket on the side of the can? It is mostly green chip-board material and it doesn't look like there is much metal there. Do I have to take the end bell off? That doesn't seem right. Seems like a stupid question, but I thought I'd better ask before I screw it up.
TPDazzle is offline   Reply With Quote