Refer to
this earlier post for background:
Today I received a BNIB MR-03 chassis set that I bought from the store here on their special. I took it out of the box, put some batteries in it, hooked it up to my Mac, powered it up with the pair button and launched the Flip Side ICS software. After setting up for the MR03 chassis, I immediately read the settings from chassis to see how it was set from the factory (I assume...). Then I hit the "Default" button to see if anything changed - and it did.
The Dead Band setting from the factory was set as "Narrow" while the default shows "Middle". All else was the same with no changes.
So, just to verify, I quit the program and ran the KO Propo ICSTuner software for Mac and it showed exactly the same scenario.
I still don't know what to make of this, but it's mildly unsettling