I was looking at the last picture were the new topdeck is shown.
and here are a few ideas...
I hope there will be more material in it when it is released to mount the electronics on (behind the servo ) As it is now there is a giant hole where the most space is in the HURDA body.
It would perhaps also be a good idea to make 2 protruding points in the rear of the topdeck that can extend in under the friction damper holding bar. So that the topdeck more clamp the batteries in. I am a bit worried that it will not be enough with the 2 small M2 bolts in the front and that the topdeck will brake in a impact.
also in my chassies it is tight on space for the steering, and it would be possible to move the servo some 3mm to the rear in the chassie by making shorter servomounts.
/Johnny
waiting for my damper and my new knuckles
|