View Single Post
Old 2018.10.07, 12:14 PM   #1
SuperFly
bitPimp
 
SuperFly's Avatar
 
Join Date: May 2004
Location: Portland, Oregon
Posts: 668
Timing bridge aperture question

I'm in the process of building a sensor bridge for an I-Lap decoder/transponder system, and I'm curious if anyone has done any testing or has any knowledge about how deep/wide the bridge channel should be.

I'm not an engineer (ha!), so I don't have the terminology to describe the distances, ratios and angles, but I think this drawing describes the question.

The sensors themselves are 1" wide, so that is the minimum interior width. I'm hoping to pick up some off-the-shelf U-channel of some sort, and just wondering about what size will work. TIA!


__________________

mini-z gallery


PDX Mini-Z
SuperFly is offline   Reply With Quote