View Single Post
Old 2017.02.22, 04:11 PM   #51
Kevinmueller
Bavarian Bullet
 
Join Date: Feb 2014
Posts: 34
Hey I just wanted to give you guys a heads up. We have had some customers break the rear motor mount with light to moderate hits. As far as we can tell this is due to the fact that the 3D printed material becomes much more brittle when it is cold (below room temperature). We did months of testing and never had any issues with the rear motor mount breaking. Last week we even had a massive impact between our chassis and a kyosho and ours walked away without a problem while the kyosho's pieces when everywhere in spectacular fashion (too bad we missed it on camera). For now we strongly recommend keeping the car at room temperature before running it. We are in the process of beefing up the rear motor mount in the mean time. Thanks
Kevinmueller is offline   Reply With Quote